The applicability of a combined thermo-mechanical drilling technique is investigated. The working principle of this method is based on the implementation of a heat source as a mean to either provoke thermal spallation on the surface or to weaken the rock material, when spallation is not possible. Thermal spallation drilling has already been proven to work in hard crystalline rocks, however, several difficulties hamper its application for deep resource exploitation. In order to prove the effectiveness of a combined thermo-mechanical drilling method, the forces required to export the treated sandstone material with a polycrystalline diamond compact (PDC) cutter are analyzed. The main differences between oven and flame treatments are studied by comparing the resulting strength after heat-treating the samples up to temperatures of 650°C and for heating rates ranging from 0.17 °C/s to 20 °C/s. For moderate temperatures (300-450°C) the unconfined compressive strength after flame treatments monotonously decreased, opposed to the hardening behavior observed after oven treatments. Thermally induced intra-granular cracking and oxidation patterns served as an estimation of the treated depth due to the flame heat treatment. Therefore, conclusions on preferred operating conditions of the drilling system are drawn based on the experimental results.
The Effects of Flame-Heating on Rock Strength: Towards a New Drilling Technology
Rossi, E., Amann, F., Saar, M. O., Kant, M. A., and P. Rudolf von Rohr. "The Effects of Flame-Heating on Rock Strength: Towards a New Drilling Technology." Paper presented at the 51st U.S. Rock Mechanics/Geomechanics Symposium, San Francisco, California, USA, June 2017.
Download citation file: