1-20 of 23
Keywords: water cut
Close
Sort by
Proceedings Papers

Publisher: BHR Group
Paper presented at the BHR 19th International Conference on Multiphase Production Technology, June 5–7, 2019
Paper Number: BHR-2019-409
... infield flow line experiment multiphase flow flow assurance challenge fluid dynamics multiphase production technology superficial gas velocity equation of state holm upstream oil & gas production control pipeline frictional pressure drop fluid modeling water cut reservoir surveillance...
Proceedings Papers

Publisher: BHR Group
Paper presented at the BHR 19th International Conference on Multiphase Production Technology, June 5–7, 2019
Paper Number: BHR-2019-425
... depends significantly on the water cut. In general, the pressure drop increases with water cut, reaching a maximum value at around WC=80%, after which the pressure drop decreases again. For three-phase experiments with tap water, the maximum pressure drop was typically 20–40% higher than for two-phase...
Proceedings Papers

Publisher: BHR Group
Paper presented at the BHR 19th International Conference on Multiphase Production Technology, June 5–7, 2019
Paper Number: BHR-2019-441
... viscosity pressure drop droplet production control water cut reservoir surveillance prediction ledaflow 2 gas zone upstream oil & gas production monitoring low liquid loading flow roughness bhr group mpt2019 high-rate low liquid loading flow production logging entrainment new model...
Proceedings Papers

Publisher: BHR Group
Paper presented at the BHR 19th International Conference on Multiphase Production Technology, June 5–7, 2019
Paper Number: BHR-2019-477
... film can become very rough, significantly increasing the frictional contribution to the pressure gradient; this is particularly significant for flows with low liquid loading, where other contributions to the pressure gradient are relatively small. water cut gas core production monitoring...
Proceedings Papers

Publisher: BHR Group
Paper presented at the 18th International Conference on Multiphase Production Technology, June 7–9, 2017
Paper Number: BHR-2017-071
... non-refractive-index-matched stratified oil-water pipe- flows at low water cuts, which represent a real field-application. This was achieved by the implementation of a combined two-line PLIF and 2-D PIV/PTV technique using two simultaneous laser sheets. The data generated can be used to improve our...
Proceedings Papers

Publisher: BHR Group
Paper presented at the 18th International Conference on Multiphase Production Technology, June 7–9, 2017
Paper Number: BHR-2017-087
..., Usg = 3 m/s, Usw = 0.4 m/s. Figure 6 shows a flow regime map for oil-water flow in the horizontal configuration, with the water cut on the horizontal axis and the mixture velocity = on the vertical axis. A noteworthy feature of this flow map is that the fully dispersed flow 92 © BHR Group 18 MPT...
Proceedings Papers

Publisher: BHR Group
Paper presented at the 18th International Conference on Multiphase Production Technology, June 7–9, 2017
Paper Number: BHR-2017-185
... Experimental data The two datasets by Elseth [2] and Amundsen [3], respectively, are complementary. Elseth presented experiments limited to horizontal flow, but spanning multiple combinations of mixture velocities and water cuts, see Table 2. Amundsen, on the other hand, presented experiments for different...
Proceedings Papers

Publisher: BHR Group
Paper presented at the 18th International Conference on Multiphase Production Technology, June 7–9, 2017
Paper Number: BHR-2017-439
... technology production control low liquid loading liquid accumulation production monitoring international conference reservoir surveillance water cut superficial gas velocity Tanzania gas development flow assurance challenges H Holm Statoil ASA, Norway ABSTRACT The subsea gas development...
Proceedings Papers

Publisher: BHR Group
Paper presented at the 18th International Conference on Multiphase Production Technology, June 7–9, 2017
Paper Number: BHR-2017-455
... conducted in both a near-horizontal 8" pipe, and a vertical 4" pipe, where particular emphasis was put on studying the effect of water cut. The measurements show that the frictional pressure drop is very sensitive to the water cut in these circumstances, even though the estimated liquid content is typically...
Proceedings Papers

Publisher: BHR Group
Paper presented at the 17th International Conference on Multiphase Production Technology, June 10–12, 2015
Paper Number: BHR-2015-D2
... a transition to stratified flow when the plate height closely matched the in situ water height at low water cuts. Introduction The flow of oil and water in pipes is commonly encountered in a number of industrial processes. These systems are particularly relevant to the oil industry in which achieving...
Proceedings Papers

Publisher: BHR Group
Paper presented at the 17th International Conference on Multiphase Production Technology, June 10–12, 2015
Paper Number: BHR-2015-F1
... of instruments for three-phase flow is performed. The focus is on the volume fraction of gas in the liquid slug. A comparison of the measured results from these two instruments is conducted, and the effect of water cut and oil-water flow regime on the void-in-slug is also analysed. The performance of some...
Proceedings Papers

Publisher: BHR Group
Paper presented at the 17th International Conference on Multiphase Production Technology, June 10–12, 2015
Paper Number: BHR-2015-J2
...Exploring the potential of model-based optimization in oil production gathering networks with ESP-produced, high water cut wells M Stanko 1, M Golan 1,2 1 Department of Petroleum Engineering, NTNU, Norway 2 MEGO A/S, Norway ABSTRACT This paper presents the application of model-based optimization...
Proceedings Papers

Publisher: BHR Group
Paper presented at the 17th International Conference on Multiphase Production Technology, June 10–12, 2015
Paper Number: BHR-2015-K1
... oil viscosity flow rate deposition equation of state multiphase 17 bhr group 2015 viscosity sm 3 water cut fluid modeling upstream oil & gas gor appearance temperature composition simulation diffusion coefficient temperature profile field observation oil rate coefficient...
Proceedings Papers

Publisher: BHR Group
Paper presented at the 16th International Conference on Multiphase Production Technology, June 12–14, 2013
Paper Number: BHR-2013-B1
... of the well. As is common with oil production wells, the water cut and water flow rate were shown to increase rapidly over the first 2 years, approaching an asymptote over the remaining life. Over the same time the oil flow rate decreased. 4.2.1 Heat transfer and hydrate weight calculation To model the amount...
Proceedings Papers

Publisher: BHR Group
Paper presented at the 16th International Conference on Multiphase Production Technology, June 12–14, 2013
Paper Number: BHR-2013-J1
.... Furthermore, experimental pressure gradients, average total liquid and water holdups, slug frequency and length data were compared with the commercial transient multiphase simulator, OLGATM, which shows a good match with high flow-rate conditions. The models validation study shows that the effect of water cut...
Proceedings Papers

Publisher: BHR Group
Paper presented at the 14th International Conference on Multiphase Production Technology, June 17–19, 2009
Paper Number: BHR-2009-C3
... to their wear resistance in multiphase environments. It will be shown how parameters such as the flow velocities, temperature, electrochemical potentials and different oil/water cuts can be investigated and how different materials perform under these conditions. The main objective of the paper is to illustrate...
Proceedings Papers

Publisher: BHR Group
Paper presented at the 14th International Conference on Multiphase Production Technology, June 17–19, 2009
Paper Number: BHR-2009-D2
... ABSTRACT Experiments were conducted to investigate low liquid loading, gas-oil-water flow behavior in a 152.4-mm ID (6-in) horizontal pipe at different gas flow rates, liquid loading levels and water cuts. Gas-liquid flow patterns and oil-water distributions were observed. The measurements...
Proceedings Papers

Publisher: BHR Group
Paper presented at the 14th International Conference on Multiphase Production Technology, June 17–19, 2009
Paper Number: BHR-2009-D4
... stratified flow multiphase production technology 14 experiment phase fraction concentration profile model prediction denote pipe production logging production control upstream oil & gas fraction oil-water flow reservoir surveillance water cut equation interface Oil-water flow...
Proceedings Papers

Publisher: BHR Group
Paper presented at the 13th International Conference on Multiphase Production Technology, June 13–15, 2007
Paper Number: BHR-2007-C1
... slug equation production logging production control production monitoring entrainment multiphase flow issa superficial velocity slug frequency bhr group 2007 slug flow fraction multiphase production technology 13 water cut upstream oil & gas experiment bonizzi fluid...
Proceedings Papers

Publisher: BHR Group
Paper presented at the 13th International Conference on Multiphase Production Technology, June 13–15, 2007
Paper Number: BHR-2007-C5
... and condensate from an onshore terminal. Fresh water and hydrate inhibitor were added, and the experiments were conducted at 75 bar pressure and a temperature of 0 °C. Experiments were conducted at +1 and +5 degree inclination angle with three different water cuts, 0, 15 and 85 % with a constant superficial...

Product(s) added to cart

Close Modal