... subsea sediments, focusing on chemical interactions and environmental impacts at the pore scale during hydrate formation and growth. Experimental studies conducted at 274.65 K temperature and 4.5 MPa injection pressure in seawater using different clay media in a continuous stirred tank reactor (CSTR...

... is discussed in Section 3, while dynamics of multiple debris impacted by a sequence of solitary waves, is discussed in Section 4. The main outcomes are summarized in Conclusion. EXPERIMENTAL SET-UP Experiments are conducted in the small hydrodynamic flume of the University of Oslo, which is 3 m long, 10 cm...

... elevation between the actual process and the system 363 model. The performance of the control system was assessed through real-time experiments with regular waves in a wave flume facility with a fully reflective vertical wall placed midway in the flume. EXPERIMENTAL SETUP A schematic diagram...

... waves depending on whether the shallow or deep draft body is placed on the weather-side. The results are benchmarked against in-house experimental data in terms of the response, wave amplification within the gap as well as surge force acting on the bodies. Broadly speaking, the simulations agree well...

... in the center of the working section, with its top rigidly fixed to the channel structure. A photograph of the setup is shown in Figure 1. The primary objective of this experiment is to validate the impact of post-processing algorithms on binocular reconstruction results, so the experimental conditions...

... in the Soxhlet extractor for 5 hrs. After sonicating the sample with DI water for 5 minutes, it was left for drying in a 60°C oven for 24 hrs. Prior to placing the sample inside the HPHT cell, it was saturated with the corresponding brine (liquid phase) for 2 hrs for each set of experiment. Experimental set-up...

... sector as a detergent. In every experiment, the liquid phase consisted of deionized water. Figure1. Schematic of the experimental setup. Experimental methodology Prior to the formation of gas hydrates, the sand bed undergoes careful preparation within the high-pressure cell reactor at room temperature...

... mineral wax inhibition asphaltene inhibition hydrate formation oilfield chemistry depositional environment silicate experiment reservoir characterization water saturation reactor gas hydrate methane hydrate experimental study methane hydrate krishna godavari flow assurance paraffin...

.... Non-wove n Carbon rovings Fig.4 Specimen preparation using TFP (left) carbon rovings integrated with non-woven (right) (dimensions are not to scale) EXPERIMENTAL SETUP The experiments are performed at ITA. The small-scale test setup at ITA for testing the filtration layer (non-woven textile...

... design criteria of tsunami protection structures, the thesis aimed to investigate into an adaptability of the formulas obtained past researches and new experimental evaluation formula derived from present research comparing with the measurements of hydraulic model experiment. INTRODUCTION On March 11...

... structure motion rao experiment resonance point installation structure yaw motion crane vessel dual crane vessel installation work Experimental and Numerical Analysis of Installation Process Using Dual Floating Crane Vessel Min Guk Seo1, Namwoo Kim1, Yoon-Jin Ha1, In Bo Park1, Bo Woo Nam1...

... condition freight & logistics services swash bulkhead lng motion platform accuracy impact pressure hot spot area stringer wave direction bulkhead marine transportation experiment Experimental Investigation on Sloshing for Independent Types B Tank of 30K LNG Bunkering Vessel Chang Seop...

... important topic. Due to the limitation of towing tank, few experimental studies have been conducted for oblique wave cases. Fujii and Takahashi (1975) carried out a series of experiments of S175 containership for different heading angles with 30 degrees intervals. Kashiwagi et al. (2004) compared...

... flow is generated between the riser and the water. In recent decades, researches of the sinusoidal motion of a cylinder in viscous fluid have been extensively studied by Bearman (1984, 1985), Sarpkaya (1986,1995) and Williamson (1985). Williamson (1985) conducted a series of experiments to investigate...

... stage under the action of irregular waves obtained by a series of measurements in a beach nourishment project in Beidaihe. EXPERIMENTAL SETUP The experiment was conducted in a 50m long, 0.8m wide and 1.2m deep glass-walled wave flume (Fig. 1). The experimental waves are generated by a piston-driven...

... response and the stability of submarine pipelines (Sumer et al., 1999; Sumer et al., 2001; Teh et al., 2003). The experiment indicated that the excessive seepage flow and the resulting piping are the major factor to cause the onset of scour beneath the pipeline. Furthermore,, the experimental results shown...

... anti-sloshing ideas keep emerging in the recent decade, trying to avoid damaging the membrane surface. free surface experiment rectangular tank foam thickness hydrodynamic pressure frequency ocean engineering amplitude flng tank history experimental study pressure sensor wave height...

... transverse force pile group coefficient side arrangement pile group effect resultant force experiment position 1 kc ld1 3 pile group structure kc 1 3 irregular wave arrangement coefficient Experimental Investigation of The Interaction Of Irregular Waves with a Side by Side Pile Group Shuxue...

... ABSTRACT International Maritime Organization (IMO)'s recent Energy Efficiency Design Index (EEDI) regulation for new ships has increased interests in ship efficiency. As a results ship added resistance is one of the key consideration in designing a highly efficient ship and many experiments...

... excitation equation viscosity i-th particle experiment calculation pressure field interface multiphase flow experimental result denote particle engineering reservoir simulation sph model chen wave elevation A multi-phase WCSPH for 2D sloshing phenomenon under the forced rolling excitation...