Abstract

Some of the heavy oil reservoirs in AIberta and Western Saskatchewan show anomalously high primary recovery and high flow rate by solution gas drive. Several theories have been proposed for the anomalous behaviour. However, only a few theories look at the basic physics of the problem and find out the reason for this favourable behaviour.

The process of solution gas drive involves nucleation of gas bubbles followed by bubble growth and finally flow of gas. In this work, the aspect of bubble growth is studied in heavy oil and in light oil. A numerical model is developed including the hydrodynamic and mass transfer effects to investigate the effect of viscous and diffusional forces on bubble growth

An objective of the paper is to show that the effect of oil viscosity on bubble growth can be ignored even for heavy oils. A secondary objective is to examine the validity of the popular growth model of R(t) = al when both diffusional and hydrodynamic forces are acting. Case of gradual decline in pressure is studied which more closely simulates the reservoir condition, and is compared with step decline in pressure. It is found that the constants a and b in the above model need to be found for the conditions of interest; they depend on oil-type, rate of pressure drop, mass transfer boundary condition etc.

In another part of the paper, the gas phase growth during solution gas drive experiment is modelled and the effect of various parameters such as viscosity, depletion rate and diffusion coefficient on the process is studied.

It is found that in a constant volumetric rate of depletion process, the system compressibility might remain unchanged for some time, even after bubbles have nucleated and while they are growing. Hence, the maximum supersaturation observed does not have to correspond with the nucleation pressure.

Introduction

The process of solution gas drive involves nucleation of bubbles in oil as the pressure falls below the bubblepoint pressure, following which the bubbles grow. During growth, the bubbles come in contact with each other and with the breaking of the lamella coalesce to form interconnected gas bubbles, often with multiple branches.

The process of solution gas drive in heavy oil reservoirs shows a number of anomalies when compared to that in a light oil reservoir. A number of theories have been proposed to explain this behaviour of the heavy oil reservoir. However, only a few look at the basic physics of the problem to find out reasons for these anomalies. In this paper an attempt has been made to study the aspect of bubble growth with specific application to the solution gas drive process by looking at the physics of bubble growth and study the effect of viscosity and other parameters on growth. As a first step, a single bubble growth in bulk is considered and the effect of porous medium is not included. The bubble growth in light oil is compared with that in heavy oil and the reason for the differences sought.

This content is only available via PDF.
You can access this article if you purchase or spend a download.