1-20 of 58
Keywords: sand production
Close
Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Proceedings Papers

Paper presented at the SPE/IATMI Asia Pacific Oil & Gas Conference and Exhibition, October 12–14, 2021
Paper Number: SPE-205757-MS
... (SCON) or thru-tubing screens as subsurface sand control. Perforation is performed by deep penetration (DP) hollow-carrier guns deployed with double-density to maximize open area and reduce sand production risk. DP charges were used based on the requirement to bypass near-wellbore damage, which...
Proceedings Papers

Paper presented at the SPE/IATMI Asia Pacific Oil & Gas Conference and Exhibition, October 12–14, 2021
Paper Number: SPE-205766-MS
... settings to improve sand production performance, the engineer needs to review these and decide if they are valid to implement at field. Performance analysis The engineer performs analysis by considering different scenarios that could help understand the consequences if well conditions change...
Proceedings Papers

Paper presented at the SPE/IATMI Asia Pacific Oil & Gas Conference and Exhibition, October 12–14, 2021
Paper Number: SPE-205790-MS
... for wells with historical sand production from current opened reservoirs. This can be achieved by checking the internal parts of choke valve, sand probe, and UT inspection on well flowline. Initial model for simulation was also built from these reservoirs and surface data. Installation and Clean up...
Proceedings Papers

Paper presented at the SPE Asia Pacific Oil & Gas Conference and Exhibition, November 17–19, 2020
Paper Number: SPE-202419-MS
... Abstract Uncontrolled sand production has caused serious complication and monetary loss in oil and gas assets worldwide especially in mature fields. It is known to be drastically limiting the production rates and damaging downhole and surface equipment, inducing the risk of catastrophic failure...
Proceedings Papers

Paper presented at the SPE Asia Pacific Oil & Gas Conference and Exhibition, November 17–19, 2020
Paper Number: SPE-202272-MS
... reaching the threshold 150 psi pressure differential across filter. This shows that the results read from the acoustic sensors tallies with the data obtained from the produced sand sampler indicating minimal to no sand production in this well. Throughout the whole campaign, similar results were seen...
Proceedings Papers

Paper presented at the SPE Asia Pacific Oil & Gas Conference and Exhibition, November 17–19, 2020
Paper Number: SPE-202300-MS
... of the following: Abstract In mature basins, sand issues can account for up to 10% of all shut-in wells either due to failure of the existing downhole sand control or onset of sand production caused by pressure depletion and/or water production. Existing remedial methodology to address sand management...
Proceedings Papers

Paper presented at the SPE/IATMI Asia Pacific Oil & Gas Conference and Exhibition, October 29–31, 2019
Paper Number: SPE-196470-MS
..., and is displayed in a heat map. It was seen that the use of beam pumps in highly tortuous wells received the number one ranking as the main cause of failures whereas sand production was revealed as the most significant parameter relating to ESP failures. Correlations for these parameters were mapped by machine...
Proceedings Papers

Paper presented at the SPE/IATMI Asia Pacific Oil & Gas Conference and Exhibition, October 29–31, 2019
Paper Number: SPE-196507-MS
... and stop proppant production which can then stop or slow down sand being produced from the formation and, by pumping crosslinked gel, obtain a longer effective proppant half-length, helping bypass damage. Background The Mangunjaya field is a mature field in South Sumatera wherein sand production...
Proceedings Papers

Paper presented at the SPE/IATMI Asia Pacific Oil & Gas Conference and Exhibition, October 29–31, 2019
Paper Number: SPE-196314-MS
... Oil & Gas sand production non-intrusive technology flow assurance flow metering comparison method production control Reservoir Surveillance drillstem/well testing acoustic sand rwfm water injection operation flow measurement installation emission air emission eor scheme operator...
Proceedings Papers

Paper presented at the SPE/IATMI Asia Pacific Oil & Gas Conference and Exhibition, October 29–31, 2019
Paper Number: SPE-196280-MS
... lift method applied in Cinta Field is Electric Submersible Pump (ESP). Sand production can create problem in ESP that lead to trip off overload or the worst is shaft broken. Loss of production due to waiting barge to replace the broken ESP will occur. Mechanical sand control has been applied...
Proceedings Papers

Paper presented at the SPE Asia Pacific Oil and Gas Conference and Exhibition, October 23–25, 2018
Paper Number: SPE-191987-MS
... the target production rate is achieved. If sand production is still observed after 6 hours, choke down until no sand is observed, keeping an observation period of 3 hours for each 2/64" choke opening. Job Execution and Results Well TN-XX1 This well was drilled to TD of 6621 ftMD and was completed...
Proceedings Papers

Paper presented at the SPE Asia Pacific Oil and Gas Conference and Exhibition, October 23–25, 2018
Paper Number: SPE-191978-MS
... Abstract The risk of sand production must be evaluated from very early stages of field development planning to select the optimum well completion, and if required, identify the appropriate sand control options. However, during the appraisal or early development stages, sand production...
Proceedings Papers

Paper presented at the SPE Asia Pacific Oil and Gas Conference and Exhibition, October 23–25, 2018
Paper Number: SPE-192090-MS
... methodologies of sand prediction were utilized to evaluate the optimum sandface completion and sand control management for the field. Empirical and analytical sand prediction based on the well logs, sidewall cores analysis, and sand prediction software are employed to evaluate the likelihood of sand production...
Proceedings Papers

Paper presented at the SPE Asia Pacific Oil and Gas Conference and Exhibition, October 23–25, 2018
Paper Number: SPE-192085-MS
... on the defined Low, Medium, and High limit for each parameter. About 85% total production from R field is coming from shallow and intermediate layers. These layers are known to be unconsolidated and prone to sand production. Hence, most of the wells were completed with sand control system, be it gravel pack...
Proceedings Papers

Paper presented at the SPE Asia Pacific Oil and Gas Conference and Exhibition, October 23–25, 2018
Paper Number: SPE-191881-MS
... Abstract Despite decades of numerical, analytical and experimental researches, sand production remains a significant operational challenge in petroleum industry. Amongst all techniques, analytical solutions have gained more popularity in industry applications because the numerical analysis...
Proceedings Papers

Paper presented at the SPE/IATMI Asia Pacific Oil & Gas Conference and Exhibition, October 17–19, 2017
Paper Number: SPE-186371-MS
... Abstract The dynamic conditions for wells present multiple challenges for conventional electrical submersible pumping systems (ESPs). Sand production, formation damage, and free gas are some of the problems that require reliable solutions to enhance the performance and run life of the ESP...
Proceedings Papers

Paper presented at the SPE/IATMI Asia Pacific Oil & Gas Conference and Exhibition, October 17–19, 2017
Paper Number: SPE-186390-MS
... possible cost reductions in order to make the overall project economically viable. One possible area for cost reduction is the sand management. Sand production is expected from the shallower I-group reservoirs targeted in the gas development. This is based on well test results conducted in one...
Proceedings Papers

Paper presented at the SPE Asia Pacific Oil & Gas Conference and Exhibition, October 25–27, 2016
Paper Number: SPE-182494-MS
... Abstract Sand screens are widely installed to control unacceptable amount of sand produced from oil and gas wells. Sand retention tests are often used to select optimal sand screen size that minimizes sand production and maximizes hydrocarbon production. However, there is currently no agreed...

Product(s) added to cart

Close Modal