1-20 of 68
Keywords: slurry
Close
Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Proceedings Papers

Publisher: Society of Petroleum Engineers (SPE)
Paper presented at the SPE/IATMI Asia Pacific Oil & Gas Conference and Exhibition, October 10–12, 2023
Paper Number: SPE-215308-MS
.... Comprehensive risk assessment including slurry design, sensitivity testing, quality control, and field trial were conducted prior to the execution. Saturated brine-based drilling fluid was utilized during drilling operations to enhance shale inhibition and prevent hole washout. No bubbling was observed in all...
Proceedings Papers

Paper presented at the SPE/IATMI Asia Pacific Oil & Gas Conference and Exhibition, October 10–12, 2023
Paper Number: SPE-215277-MS
... and materials cement property slurry contamination cement batch mixer geopolymer slurry cement formulation drilling fluid chemistry geopolymer cement geologist geology subsurface storage environmentally friendly co resistance cement laboratory drilling fluid selection and formulation climate...
Proceedings Papers

Paper presented at the SPE/IATMI Asia Pacific Oil & Gas Conference and Exhibition, October 12–14, 2021
Paper Number: SPE-205559-MS
... Abstract Tailoring slurry designs using amorphous liquid silica base has been a success for Cementing Extended Reach Drilling (ERD) wells in Brunei in development fields. The use of this unconventional slurry density and design has helped to achieve the necessary top of cement and required...
Proceedings Papers

Paper presented at the SPE/IATMI Asia Pacific Oil & Gas Conference and Exhibition, October 12–14, 2021
Paper Number: SPE-205622-MS
... oil & gas mud density objective placement well control cement chemistry pore pressure narrow operating pressure window petroleum engineer hpht well slurry mexico Introduction Day after day new limitations on the construction of a well, that before seemed impossible, are being...
Proceedings Papers

Paper presented at the SPE Asia Pacific Oil & Gas Conference and Exhibition, November 17–19, 2020
Paper Number: SPE-202291-MS
... the dune propagation ( Lemesnager et. al. 2008 ). During the gravel packing, the CAPS system uses simultaneous flow in three distinct but interdependent annuli. The system provides two annular flow paths for slurry placement. If a bridge starts to occur in one flow path, the slurry will reapportion...
Proceedings Papers

Paper presented at the SPE Asia Pacific Oil & Gas Conference and Exhibition, November 17–19, 2020
Paper Number: SPE-202296-MS
... returns through the riser. Roping behavior of the pre-pad and slurry have also been studied, and results presented to correlate with design. All open-hole gravel packs were executed without losses and achieved complete packs. Finally, flowback and well test data were analyzed by the operator and found...
Proceedings Papers

Paper presented at the SPE/IATMI Asia Pacific Oil & Gas Conference and Exhibition, October 29–31, 2019
Paper Number: SPE-196545-MS
... For many years the transition time had been recognized by the term of Right Angle Set (RAS) which is the time of slurry consistency undergoes from pumpable to non-pumpable condition. Grant, Dodd, & Gardner, 1989 , define RAS slurry as the cement slurries have relatively low consistency...
Proceedings Papers

Paper presented at the SPE/IATMI Asia Pacific Oil & Gas Conference and Exhibition, October 29–31, 2019
Paper Number: SPE-196426-MS
.... The species model and the viscous laminar model have been applied, and the velocity inlet and the outflow outlet have been set as the boundary conditions. Both the mud, the spacer and the cement slurry are non-Newtonian Herschel-Buckley(H-B) fluids, whose rheological properties are determined by the flow...
Proceedings Papers

Paper presented at the SPE/IATMI Asia Pacific Oil & Gas Conference and Exhibition, October 29–31, 2019
Paper Number: SPE-196535-MS
... blending and pumping a slurry consisting of a gelled carrier fluid and proppant at a concentration between 3 and 4 ppg at a pump rate of approximately 4 bpm to place a proppant pack in the annulus between a set of screens and the openhole formation face, as well as a portion of the blanks. To place...
Proceedings Papers

Paper presented at the SPE/IATMI Asia Pacific Oil & Gas Conference and Exhibition, October 29–31, 2019
Paper Number: SPE-196262-MS
... slurry using hollow microspheres. While desired characteristics of the slurry and cement where achieved in the laboratory, Brunei's operations faced design execution challenges because of the following: Standard execution systems for the beaded slurries require the beads to be blended...
Proceedings Papers

Paper presented at the SPE Asia Pacific Oil and Gas Conference and Exhibition, October 23–25, 2018
Paper Number: SPE-192032-MS
... circulation new drilling string design society of petroleum engineers coal bed methane complex reservoir slurry coalbed methane loss zone drilling fluids and materials cement slurry Drilling drilling fluid management & disposal coal seam gas Introduction Early Permian Coals have been...
Proceedings Papers

Paper presented at the SPE Asia Pacific Oil and Gas Conference and Exhibition, October 23–25, 2018
Paper Number: SPE-192107-MS
... impossible using conventional methods because of geology, directional profile, standoff, and hydraulics. Cement slurry properties Abstract The Vostochno-Messoyakhskoe field is the northernmost active continental field in the Russian Federation ( Fig. 1 ). This field is located 250 km from the Arctic...
Proceedings Papers

Paper presented at the SPE Asia Pacific Oil and Gas Conference and Exhibition, October 23–25, 2018
Paper Number: SPE-191892-MS
... that foamed cement can be used as an alternative to traditional lightweight and/or elastomeric cement slurries. Further, the benefits of foamed cement make it an economically and technically advantageous solution compared to conventional cementing techniques used to overcome CSG challenges. This case study...
Proceedings Papers

Paper presented at the SPE Asia Pacific Oil and Gas Conference and Exhibition, October 23–25, 2018
Paper Number: SPE-192104-MS
... for the depleted zones ranged from 11.0 to 11.28 lbm/gal. The measured depth (MD) of these wells was more than 4500 m (MDRT). Mud weights ranged from 10.9 to 11 lbm/gal in the well while drilling the zone. The length of the liner normally ranged from 1400 to 2300 m. The cement slurry was finalized after conducting...
Proceedings Papers

Paper presented at the SPE/IATMI Asia Pacific Oil & Gas Conference and Exhibition, October 17–19, 2017
Paper Number: SPE-186930-MS
..., execution, and well evaluation. The field requirement was to design a gas-tight, lightweight slurry for a production zone to treat losses and address issues of SCP. A finite element analysis (FEA) structural simulation was performed, which modeled the lifetime operation of the well. Including elastomeric...
Proceedings Papers

Paper presented at the SPE/IATMI Asia Pacific Oil & Gas Conference and Exhibition, October 17–19, 2017
Paper Number: SPE-186964-MS
... evaluation logs, was performed on the first four wells, with the key objective to identify the root cause for the microannulus response. The root cause for the microannulus in these four wells was successfully identified, besides verifying the centralizers’ performance and mud rheology in slurry displacement...
Proceedings Papers

Paper presented at the SPE/IATMI Asia Pacific Oil & Gas Conference and Exhibition, October 17–19, 2017
Paper Number: SPE-186918-MS
... cement pipe mechanical back ppg well control POOH liner coil slurry torque Circulate reservoir cement squeeze job hole size assembly jurassic reservoir Introduction Kuwait has developed the deep, sour Jurassic reservoirs in the West Kuwait area fields over the past 25 years...
Proceedings Papers

Paper presented at the SPE/IATMI Asia Pacific Oil & Gas Conference and Exhibition, October 17–19, 2017
Paper Number: SPE-186976-MS
... Abstract During primary cementing of coalbed methane (CBM) wells, it is necessary to consider slurry designs not typically encountered during conventional cementing operations. An important difference between coal seams and conventional reservoirs is the cleat system of coal. This unique...
Proceedings Papers

Paper presented at the SPE/IATMI Asia Pacific Oil & Gas Conference and Exhibition, October 17–19, 2017
Paper Number: SPE-186441-MS
... inside another largercylinder and cured after filling the annular space with cement slurry. Once cured, the shear-bond strength was experimentally measured using a hydraulic press. The results obtained with various coating materials are compared to those from an uncoated control sample. The shear-bond...

Product(s) added to cart

Close Modal