... artificial intelligence compressor adaptation technique performance modeling sensitivity analysis compressors engines and turbines efficiency site compressor pressure ratio spe 154136 gpa index speed curve fouling compressor degradation degradation Introduction The performance...

... in order to get a representative range of operational conditions. Conclusions are made on the capabilities of the new method to assess the impact of Gas on the ESP operational performances. reservoir surveillance efficiency inlet condition production control flow metering flow rate vfm data...

... between the abrasive jetting tool and the casing or open hole. Each factor can play a major role affecting the final outcome. It is very important to understand the role of these factors in order to utilize the tool at its maximum efficiency. Nozzle Size The higher the number and size...

... KHI may have negative impact on the environment during discharge, efficient treatment solutions to remove KHI are needed. The objective of the present laboratory investigation is to address the various treatment methods, namely membrane process and advanced oxidation process for removal of KHI...

... scavengers are designed for neutral-high pH conditions, while aldehyde-based scavengers are intended for low pH conditions. However, reaction products of these scavengers with H 2 S could lead to potential formation damage. The efficiency of two Triazine-based H 2 S scavengers were investigated over a wide...

... the modifications made to the burner system, and H 2 S removal from the gas and oil phases. Also a new methodology is presented that fully controlled oil and gas flow to the burner to mitigate the risk of burner flameout for the highest burning efficiency, minimizing spills, and enhancing safe operation...

... to verify on a real case its applicability and efficiency. The technology aims at the improvement of the oil recovery and at the reduction of the water production. This methodology is applied for oil mature fields, that are subjected to the water injection and that are presenting a heterogeneous reservoir...